Electric Gate Installation Services

Automated Entry Systems

Automating a manual gate starts with checking gate weight, alignment, and hinge or track condition, a misaligned gate will overload any motor. The installer then selects a compatible control board, routes wiring, mounts safety sensors, and runs a full movement and response test before the system goes into daily use.

Automatic Gate Installation

Automatic gate installation covers every layer: site grading, post setting, gate hardware, electrical rough-in, motor mounting, keypad and remote pairing, and a final cycle test. Motor selection accounts for gate weight and daily cycle count, so the operator is not undersized for a wide mountain estate entrance.

Cantilever Slide Gates

A cantilever slide gate rides on wheel carriages bolted to posts, with a counterbalanced tail section that keeps the panel suspended clear of the ground. The clear opening can span 20 feet or more without a track, making it the standard choice for wide acreage entrances on gravel or uneven surfaces.

Cellular Access Control

A SIM card installed in the gate controller receives an incoming call or app command, then fires a relay that triggers the existing gate operator. Access is managed through a caller ID whitelist, so only approved numbers can send the open command, no physical remote required.

Electric Gate Installation

Site conditions, slope, surface, available power, and opening width, determine which gate type and operator will actually perform. We connect you with a local installer who sizes the motor, runs the conduit, sets travel limits, and cycle-tests the full system before signing off.

High-Speed Mountain Gates

Standard residential openers are rated for low daily cycle counts on flat driveways. Mountain estate entries need operators rated for high-frequency use on grade, with battery backup for outages and photo eye sensors that meet UL 325 requirements. The installer sizes the motor to the gate weight and slope load before any hardware is ordered.

Industrial Security Gates

Commercial and industrial sites need operators rated for 100 or more cycles per day and gate panels wide enough for delivery trucks. Keypad, card reader, or intercom integration controls who enters without on-site staffing. The installer confirms opening width, available clearance, and operator cycle rating before any hardware is specified.

Solar Powered Gate Systems

A solar gate system is only as reliable as its weakest component. Panel output, battery reserve capacity, and charge controller rating all have to match the operator’s draw and the property’s daily cycle count. We connect you with a local installer who sizes the full power chain before any hardware is ordered.

Vertical Lift Gates

Where a slope blocks a swing arc and a fence line blocks a slide run, a vertical-lift configuration is the only practical fit. The panel travels straight up on a motorized pulley or hydraulic cylinder, so there is no ground track to freeze and no side room required.

Wildfire-Resistant Gate Fabrication

Wood and vinyl gates ignite under ember cast and radiant heat common in high fire hazard severity zones. Steel frame and aluminum panel construction eliminates that ignition path. A battery-backed operator keeps the gate moving during a power outage, and a manual release allows hand operation when an evacuation leaves no time to wait for a motor.